Difference between revisions of "IoT - ESP-07 Everything!"
Jump to navigation
Jump to search
| Line 27: | Line 27: | ||
[[File:ESP-07 With Bodges.jpg|none|thumb|Let's play a game of "Spot the Bodges"]] | [[File:ESP-07 With Bodges.jpg|none|thumb|Let's play a game of "Spot the Bodges"]] | ||
| − | + | ||
| + | [[File:More Success.png|none|thumb|But, at least it works...]] | ||
Guess this one gets a respin. | Guess this one gets a respin. | ||
[[File:07 vs 12.jpg|none|thumb|Yes... ESP-12 will fit & work... But...]] | [[File:07 vs 12.jpg|none|thumb|Yes... ESP-12 will fit & work... But...]] | ||
ESP-12 will work (without getting the extra pins), but it'll stick out a bit. | ESP-12 will work (without getting the extra pins), but it'll stick out a bit. | ||
Latest revision as of 14:27, 5 November 2020
This board carries the ESP-07 module.
The Gerbers (v0.1.2 board... Bodges needed...)
(Front).jpg)
(Back).jpg)
The boards have arrived.
Should also accept the ESP-12. I have a few of each module on the way. Guess I'll find out...
Sadly, the modules will arrive sometime in the middle of next month. :(
Or, Maybe Monday... If Canada Post is more believable that Banggood...
So...
Installed an 07 module & spent a day trying to figure out why in hell it wouldn't respond to the programmer.
- The Chip Enable pin needs to be pulled high... DOH!
- GPIO15 needs to be pulled low... (Really? Huh...)
Guess this one gets a respin.
ESP-12 will work (without getting the extra pins), but it'll stick out a bit.
