Difference between revisions of "MCU - Display - TFT"

From The TinkerNet Wiki
Jump to navigation Jump to search
Line 13: Line 13:
 
[[File:TFT-Whew.jpg|thumb|link=Special:FilePath/TFT-Whew.jpg]]
 
[[File:TFT-Whew.jpg|thumb|link=Special:FilePath/TFT-Whew.jpg]]
 
[[File:TFT-StillWorks.jpg|thumb|link=Special:FilePath/TFT-StillWorks.jpg]]
 
[[File:TFT-StillWorks.jpg|thumb|link=Special:FilePath/TFT-StillWorks.jpg]]
 +
[[File:TFT-Wired.jpg|thumb|link=Special:FilePath/TFT-Wired.jpg]]
  
 
====Pins====
 
====Pins====

Revision as of 01:01, 25 November 2020

ILI9341 SPI TFT LCD Display Touch Panel

2.8 Inch ILI9341 240x320 SPI TFT LCD Display Touch Panel SPI Serial Port Module

TFT-Front.png
TFT-Back.png
TFT-1st Test.jpg
TFT-Tasmotized.jpg
TFT-InaBox.jpg
TFT-NotWired.jpg
TFT-Aaarrrggg.jpg
TFT-FingersCrossed.jpg
TFT-Connections.jpg
TFT-Whew.jpg
TFT-StillWorks.jpg
TFT-Wired.jpg

Pins

Nailbuster
Examples
Label Signal {colour} NodeMCU Actual
14 T_IRQ WHI D1 GPIO5
13 T_DO (MISO) GRY D6 GPIO12
12 T_DIN (MOSI) VIO D7 GPIO13
11 T_CS SPI select BLU D2 GPIO4
10 T_CLK SPI clk GRN D5 GPIO14
9 SDO(MISO) (MISO) GRY D6 GPIO12
8 LED RED+ VCC 3v3
7 SCK SPI clk GRN D5 GPIO14
6 SDI(MOSI) (MOSI) VIO D7 GPIO13
5 D/C ORA D4 GPIO2
4 RESET YEL VCC 3v3
3 CS SPI select BRN D8 GPIO15
2 GND BLK GND GND
1 VCC RED VCC 3v3

(Why in hell do dev-board makers, & Arduino for that matter, think changing the actual GPIO numbers to some random shit was a good idea???)

Firmware

Seems to work pretty good with Tasmota-Display.

Links